View Single Post
Old 05-08-2015, 10:16 AM   #1
geaux_preaux
 
Status: Junior Member
Join Date: May 2015
Posts: 2
Default Polishing/Removing Holograms after Marine 31 Heavy Oxidation remover

Started using the Marine 31 product line this year and really fell in love with the Marine 31 Heavy oxidation remover. It cuts faster than another commonly used marine product line, and leaves very faint halo's and buffer trails. I'm using the heavy oxidation remover with a dewalt rotary 879x, with double sided 100% wool pads. It finishes out great, but when i go to polish out the halo's with Marine 31 AIO, or Marine 31 Final Step polish it "dulls" the surface, and leaves a few buffer lines. I have tried using the dewalt with a black polishing pad at varying speeds, a flex vrg 3401 with white lake country pad, green lake country pad, and black polishing pad, and i have also tried the griots DA with same pads as the flex and still not getting 90-100% correction like I am wanting. I did have a few older 6.5" PFW pads and i tried them on the dewalt and the flex. The dewalt gave better results, but still leaving faint halos and trails. The only way i can see the marks is when i have my halogen lights at an angle on the surface. Any thoughts or pad combo's that i should be using with the polishes to get where i want it? Thanks
geaux_preaux is offline   Reply With Quote